Size-fractionation and characterization of landfill leachate and the improvement of Cu2+ adsorption capacity in soil and aged refuse

Leachate was collected from an anaerobic lagoon at Shanghai Laogang refuse landfill, the largest landfill in China, and the sample was separated into six fractions using micro-filtration membranes, followed by ultra-filtration membranes. Several parameters of the samples were measured, including chemical oxygen demand (COD), total organic carbon (TOC), total solids (TS), pH, total phosphate (TP), total nitrogen (TN), fixed solids (FS), NH4+, orthophosphate, color, turbidity, and conductivity. These parameters were then quantitatively correlated with the molecular weight cutoff of the membrane used. Organic matter in the dissolved fraction (MW<1kDa) predominated in the leachate, accounting for 65% of TOC. Thermal infrared spectroscopy was used to characterize the filter residues. Asymmetric and symmetric stretching of methyl and methylene groups, and of functional groups containing nitrogen and oxygen atoms, were observed. In addition, the ability of two different samples to adsorb heavy metals was tested. Cu2+ was chosen as the representative heavy metal in this study, and the samples were soil; aged refuse, which had spent 8 years in a conventional sanitary landfill; and samples of soil and aged refuse treated for 48h with leachate in the ratio of 5g of sample per 50ml of leachate. Cu2+ uptake by the raw soil was approximately 4.60microg/g, while uptake by the leachate-contacted soil and leachate-contacted aged refuse were 5.66 and 5.11microg/g, respectively. These results show that the organic matter in the leachate enhanced the capacity of aqueous solutions to adsorb Cu2+.     

ASBBR-二级SBBR-化学除磷组合工艺处理榨菜腌制废水

针对榨菜腌制废水高盐高氮磷高有机物浓度的特征,提出"厌氧序批式生物膜反应器(ASBBR)-二级序批式生物膜反应器(SBBR)-化学除磷"组合处理工艺,在前期对组合工艺中单元工艺的关键工况参数研究的基础上,考察组合工艺的处理效能。实验结果表明,采用该组合工艺,可使进水COD、NH4+-N、TN及PO43--P分别为10 000、345、550和38.5mg/L的榨菜腌制废水,处理出水COD、NH4+-N、TN及PO43--P分别达到93.6、12.3、18和0.1 mg/L,去除率分别为99.1%、96.4%、96.7%和99.9%,出水达到污水综合排放一级标准。     

Distribution and transport characteristics of fine particulate matter in beijing with mobile lidar measurements from 2015 to 2018

Accurately quantifying the concentration and transport flux of atmospheric fine particulate matter (PM_2.5) is vital when attempting to thoroughly identify the pollution formation mechanism. In this study, the mobile lidar measurements in Beijing on heavily polluted days in December from 2015 to 2018 are presented. The lidar was mounted on a vehicle, which could perform measurements along designated routes. On the basis of mobile lidar measurements along closed circuits of the 6th Ring Road around Beijing, the spatial distribution and transport flux of PM_2.5 in Beijing were determined with information of wind field. In the spatial distribution, both the concentration and transport of PM_2.5 were revealed to be more significant in the southern section of Beijing. The regional transport layer at heights < 1.3 km plays an important role in pollution formation. The maximum transport flux reached 1600 μg/(m²*sec) on 11 December 2016. With the aerosol boundary layer height determined from the image edge detection (IED) method, the inter-annual variations of the aerosol boundary layer height (ABLH) were also analysed. The ABLH decreased from 0.73 to 0.46 km during the same heavy pollution period from 2015 to 2018. Increasingly adverse aerosol boundary layer (ABL) meteorological factors, including lower ABLH, light winds, temperature inversions, and accumulated moisture, have become necessary for pollution formation in Beijing.     

Investigation of PM2.5 pollution during COVID-19 pandemic in Guangzhou, China

The COVID-19 pandemic has raised awareness about various environmental issues, including PM_2.5 pollution. Here, PM_2.5 pollution during the COVID-19 lockdown was traced and analyzed to clarify the sources and factors influencing PM_2.5 in Guangzhou, with an emphasis on heavy pollution. The lockdown led to large reductions in industrial and traffic emissions, which significantly reduced PM_2.5 concentrations in Guangzhou. Interestingly, the trend of PM_2.5 concentrations was not consistent with traffic and industrial emissions, as minimum concentrations were observed in the fourth period (3/01-3/31, 22.45 μg/m³) of the lockdown. However, the concentrations of other gaseous pollutants, e.g., SO₂, NO₂ and CO, were correlated with industrial and traffic emissions, and the lowest values were noticed in the second period (1/24-2/03) of the lockdown. Meteorological correlation analysis revealed that the decreased PM_2.5 concentrations during COVID-19 can be mainly attributed to decreased industrial and traffic emissions rather than meteorological conditions. When meteorological factors were included in the PM_2.5 composition and backward trajectory analyses, we found that long-distance transportation and secondary pollution offset the reduction of primary emissions in the second and third stages of the pandemic. Notably, industrial PM_2.5 emissions from western, southern and southeastern Guangzhou play an important role in the formation of heavy pollution events. Our results not only verify the importance of controlling traffic and industrial emissions, but also provide targets for further improvements in PM_2.5 pollution.     

Biotreatment of chromite ore processing residue by Pannonibacter phragmitetus BB

Chromite ore processing residues (COPR) is the source of the Cr(VI) contamination in the environment. Pannonibacter phragmitetus BB was used to treat two different types of COPRs in this research. The water-soluble Cr(VI) of COPR A and B is 3,982.9 and 1,181.4 mg/kg, respectively. In the column biotreatment process, P. phragmitetus BB can reduce Cr(VI) in the leachate to an undetectable level at the flow rate of 1 and 2 ml/min. In the direct biotreatment process, Cr(VI) in the liquid supernatant of COPR A and B decreased from 265 and 200 mg/l to 145 and 40 mg/kg after 240 h of incubation. In one-step and two-step biotreatment processes, Cr(VI) in the liquid supernatant of both COPRs can be reduced to an undetectable level. The toxicity characteristic leaching procedure results indicate that the Cr(VI) concentration of treated COPR A (3.48 mg/l) is lower than the identification standards for hazardous wastes of China (5 mg/l) (GB 5085.6-2007). The information obtained in this study has significance for the application of P. phragmitetus BB to remediate COPR contamination.     

3种载体固定化菌藻共生系统脱氮除磷效果的对比

采用3种不同载体（海藻酸钠、聚乙烯醇、复合载体）,分别将小球藻和栅藻与活性污泥固定成菌藻共生系统,制成菌藻凝胶小球,单独菌、单独藻的凝胶小球,用于处理人工污水。结果表明,（1）复合载体固定的菌藻共生系统氮磷去除效果最好,PVA载体的脱氮除磷效果次于复合载体优于海藻酸钠;（2）固定化菌藻共生系统的脱氮除磷效果明显优于单独固定菌和单独固定藻,固定菌的效果较差;（3）3种载体包埋下的固定化小球藻的脱氮除磷效果均较相同载体固定化的栅藻效果好。     

光催化氧化处理低浓度含醇废水实验

室内实验了TiO2紫外光催化氧化处理废水中的低浓度甲醇。通过对TiO2催化剂活性及添加方式、溶液pH、紫外光强与催化剂加量等参数优化,在TiO2加入浓度为300mg/L和120 W紫外灯照射条件下,对6.8L甲醇浓度为2.77%的低浓度含醇废水持续处理70min后,废水中的甲醇去除率可达98.31%。该实验为进一步处理低浓度含醇废水提供了方法依据。     

利用污泥熟肥作为高含水率污泥堆肥调理剂

采用静态强制通风好氧堆肥的方法,以木屑作为对比,考察了利用污泥熟肥作为调理剂对污泥堆肥过程的影响。结果表明,与以木屑作为调理剂的污泥堆体(对照组)相比,以污泥熟肥作为调理剂的污泥堆体(实验组)升温快,高温阶段(>50℃)持续时间长达10 d,满足粪便无害化卫生标准的要求,而对照组仅持续了2 d;实验组腐熟的堆肥含水率从60%降到39%,下降了21%,pH维持在7.5～8.5范围内,微生物活性较强,而对照组含水率仅下降15%,pH始终低于7.5;实验组种子发芽指数(GI)在第14天就回升到80%以上,基本上去除了植物毒性,而对照组GI在第22天才回升到50%。总体而言,污泥熟肥能显著改善堆肥中微生物的微环境,促进有机物的降解,缩短堆肥腐熟时间,是一种优质的调理剂。     

Role of black carbon in the distribution of polychlorinated dibenzo-p-dioxins/dibenzofurans in aged field-contaminated soils

Floodplain soils containing elevated levels of polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDD/Fs) were collected from several locations along the Tittabawassee River (Michigan, USA). The PCDD/F profiles of these soils exhibited distinct congener patterns consistent with byproducts from either chloralkali manufacturing or chlorophenols productions. Black carbon (BC) particles were isolated for the first time from floodplain soil impacted by PCDD/Fs. Petrographic analysis showed that BC particles, including coal, oxidized coal, metallurgical coke, depositional carbon, coal tar/pitch, cenosphere, and charcoal, comprised approximately 30% by volume of the organic fraction with size range of 250 μm-2000 μm from a typical floodplain soil. The BC particles with anthropogenic origin such as pitch and coke associated with the chloralkali production process served as both the source and subsequent transporter for the highly hydrophobic PCDD/Fs. These anthropogenic BC particles were enriched with high levels of PCDFs, containing approximately 1000-fold the concentration found in the bulk soil. The strong association of PCDD/Fs with anthropogenic BC directly impacts the physicochemical and biological availability thus the risk associated with these hydrophobic organochlorines in soils and sediments.     

Production of the monoclonal antibody against tylosin for immunoassay of macrolide antibiotics in milk

The objective of the present study was to develop an immunoassay for multi-determination of the residues of four macrolide antibiotics in milk. Tylosin was derivatized with 6-aminohexanoic acid to synthesize a hapten that was used to produce the monoclonal antibody. The obtained monoclonal antibody simultaneously recognized tylosin, acetylisovaleryltylosin, tilmicosin and desmycosin with crossreactivities of 100%, 91%, 49% and 76%, respectively. Then an indirect competitive immunoassay was developed to determine the four analytes in milk simultaneously. The limits of detection for the four analytes were in the range of 5.5–11.7 ng/mL depending on the compound. The recoveries of the four analytes from fortified blank milk were in the range of 78%–96% with coefficients of variation lower than 11.4%. The developed immunoassay could be used as a practical tool for rapid screening the residues of the four anlytes in milk.